guinomi

The First Pots: Chawan and Guinomi

Here are some of the first pots to get cleaned up after the firing last week. I’ll post more over the next few days as I get things cleaned up.

Overall the firing went well, much better than the first two certainly. I’m finally starting to get a grip on how the kiln climbs, and learning not to worry about it too much. We fired both chambers this time and it took roughly 30 hours. Cone 10 flat in front, cone 9 touching in the rear, and cone 13 almost touching in the second chamber. The second chamber is a pleasure to fire, very relaxing after stoking the front. I think I can still get more aggressive with the front, taking the temp up even more, probably somewhere around cone 12 would be good for the rice straw ash glazes.

The intention was to drop cone 6 in the rear and call it quits, but it ended up getting hotter than expected, and the ware in front ended up a little too shiny. However, the middle and rear of the setting came out just about perfectly. Temp from top to bottom was quite even. We stopped stoking the second chamber when cone 11 dropped and clammed everything up after letting some of the excess heat out. Still, when I peeked in the next morning, that second chamber was still glowing, and cone 13 was mostly down. Guess that 1250kg of insulating castable does its job well.

Most of the failures this time around were caused by bad glazing, not the firing. Rice straw ash glazes were universally too thick, and an ash glaze I whipped up hoping to be a nice runny green ended up being a crusty reddish brown. Oops.

Karatsu Show

This last weekend we had the show in Karatsu.  It was a 3 day weekend, so we did Sat, Sun, Mon. Well, if you are thinking about having a show on a 3 day weekend, let me give you a little advice: don’t. Everyone goes somewhere else. The first two days were absolutely empty, and it was only the during the last day that I was able to make some good sales. Thanks to guests from Osaka, Kyoto, and Chiba. I guess they were using the 3 day weekend to get out of their respective areas as well.

Well, lesson learned. Overall, it was still a very enjoyable experience, with lots of time to sit and chat with friends over tea. The highlight of the show was without a doubt, the shiboridashi teapot with the river crab knob. It is a pure silver crab holding a ruby in his right claw.

Pictures from the latest firing

Below are some pictures from the latest firing (of the gas kiln). There were a few nice pots in the firing, enough to fill in the gaps with the show next week. Lost most of the chawan and guinomi, but got a couple of each that I like.

Chosen Garatsu (the runny white over brown) constantly reminds me that I need more practice. Just when I think I’ve got it down, it shows me just how much I don’t know.

Kamadashi / and a nasty case of the runs

I unloaded the kiln yesterday evening, confirming my suspicions about my glazing skills. While I got some good smaller ‘souvenir’ level work out of the kiln, the chawan and guinomi were for the most part not so good. These are the higher yen items, so I like to get more of those than less, but it does not oft happen. Two problems with them this time: the iron glaze was a bit thin, because the water was a bit too deep in my foot soaking dish, and my band of rice straw ash glaze at the top was a bit too thick.

The pieces that I needed for the upcoming show were the small dishes and yunomi, and for the most part they came out great, aside from about 10 that really ran, and had super duper pinholing. The smaller dishes that I tried out my copper green on turned out nicely as well, looking like a cross between an Oribe green and a Nuka Seiji.

I’ll post pictures of some individual pieces in the next few days, but for now here are the unloading pictures: