{"id":1771,"date":"2013-12-31T15:49:23","date_gmt":"2013-12-31T06:49:23","guid":{"rendered":"http:\/\/karatsupots.com\/wordpress\/?p=1771"},"modified":"2013-12-31T16:04:56","modified_gmt":"2013-12-31T07:04:56","slug":"8th-wood-firing-photo-record","status":"publish","type":"post","link":"https:\/\/karatsupots.com\/wordpress\/2013\/12\/8th-wood-firing-photo-record.html","title":{"rendered":"8th Wood Firing Photo Record"},"content":{"rendered":"

This post is a photo record with comments, in order to organize and retain my thoughts and observations about the 8th firing of the wood kiln. I always think I’ll remember until the next firing, but never do. So, if you get into this, beware there are a LOT of pictures, some of which may seem redundant. There are examples of most of the pots from the firing, minus teabowls and some others which are not photographed yet.<\/p>\n

The 8th firing was a charm overall, with many good pots, some bad, and some that will get refired. Kiln was fired in oxidation primarily. We stoked once every 30 minutes for 2 1\/2 days, then once every 20 minutes the last half day.<\/p>\n

– Front was nicely melted, nice even gradient to the rear of first chamber, E-Karatsu was about ideal. Cone 12 at hottest front down to cone 6 at coolest rear.<\/p>\n

– Front chamber behaves like anagama. No significant temp gradient from front to back of each setting. Next firing, will pack kiln by eliminating the space between settings, leaving horizontal space for flame travel. One long setting from front to back of first chamber.<\/p>\n

– Ame yu better at low temps. Load rear to mid chamber.<\/p>\n

– Ao yu needs more heat, mid to front chamber.<\/p>\n

– Large platters go midway to back of front chamber. Too much ash up front.<\/p>\n

– Firebox wares are very nice in a three day firing. Great place for Shino, under cover to avoid ash in pots.<\/p>\n

– Rear chamber fires fast when preheated for 3 days. Jumped from 1044C to 1344C in four stokes, a little over an hour. Care must be taken to spend more time soaking at high temp, because rear chamber high temp wares not quite mature (surface changes only), clay not melted well. Spend 3 or 4 hours firing off rear chamber, slowly, to get inside the pots.<\/p>\n

– Rear chamber fires very evenly front to back, and top to bottom. Pick a temp to fire at and load accordingly. Don’t expect a significant gradient.<\/p>\n

 <\/p>\n