Clay clay clay

When I was polishing work from the fall firing yesterday, I noticed two pieces that had been glazed, fired (on shells)glazed again, and fired again (on shells). This isn’t too unusual, but in the case of these two pieces, they were literally fired side by side both times and had the same glazes applied, twice.

The only difference between the pieces is the clay body. The teabowl is clay/sandstone 50/50, and the smaller cup is clay/sandstone 10/90.

Now probably it shouldn’t, but the difference in the fired glaze surface astounds me. And all other things being equal, it must be that 40% difference in clay content that has changed that glaze.

Since the glaze is collected, I don’t have an analysis, but my guess is that the higher alumina content in the higher clay body is responsible for making that high silica glaze go clear, by adding alumina to the glaze matrix and fluxing more of the silica.

3 thoughts on “Clay clay clay”

    1. The amount of ash should be the same since they were fired side by side. The larger bowl has more surface area, but they should theoretically have received the same amount of ash per square cm.

Leave a Reply

Your email address will not be published. Required fields are marked *