Kickwheel Conversion Finished

The kickwheel conversion is finally finished. Here are some pictures of the flywheel getting put together:

Douglas Fir beams glued up and drying.  After drying, knocked the corners off with a chainsaw, then knocked off corners again to get a basically round shape.
Douglas Fir beams glued up and drying. After drying, knocked the corners off with a chainsaw, then knocked off corners again to get a basically round shape.
Corners knocked off, planed the edge to soften and round.
Corners knocked off, planed the edge to soften and round.
Planed and sanded, ready to go on the frame.
Planed and sanded, ready to go on the frame.
Placed on the frame, spun, and centered. Then, clamped on in place, turned over and screwed in (not shown)
Placed on the frame, spun, and centered. Then, clamped on in place, turned over and screwed in (not shown)
Reassembled and ready to go!
Reassembled and ready to go!

And it was just as easy as that.  Many thanks again to Yamaguchi kun for making the flywheel armature!

And here I am taking it out for a spin:

One thought on “Kickwheel Conversion Finished”

Comments are closed.