Made a dent in the wood pile today…

Spend a good bit of time sorting and splitting wood for the next couple of firings today. Before the kiln was built, Craig Edwards mentioned on a couple of occasions that having the wood split and sorted makes for a much easier time firing. I understood the need for splitting, but sorting kind of stumped me. I couldn’t understand why sorting for length would help, thinking that one could estimate the volume of wood going in each stoke, more shorter pieces or less longer pieces, right?

This seems to work in theory, but when you start adding in factors like stoking under the grates vs over the grates, or doing the wooden door technique, or side stoking through a smaller hole that tilts down, then the size and length of the faggots gets pretty important pretty fast. Having to sort through a stack for  the right size during the firing makes for a stressful time. Having the right size stacked in the right place so that it doesn’t need  to be moved a lot really cuts down on the labor.

So, this time I culled out all of the longest wood and split it first, stacking it near the front of the kiln. Shorter fat pieces near the front as well, with thinner pieces toward the middle and rear for side stoking the front and rear chambers. Also a special section of extra long pieces for doing a wooden door type stoke to get over stalls, if they happen. Here are some pictures of the stacks, plus a little potter porn.