Here comes the flood

Not!

The concrete combined with the sump pump is doing its job admirably. I took these pictures this morning after a night of med/heavy rain (but nothing close to the storm last evening). Water has started to seep in places, and since the part in the foreground is not under cover, some rain falls right in, but that will only be a problem during firing.  Last firing there was some rain and I strung a tarp down at an angle from the cover which worked alright, if not very elegant.

Here are the pictures of everything when it is moderately wet. Water is collecting around the edges of the concrete, but even in the heavy rain yesterday, was unable to reach the top. The sump pump has activated at least once, judging from the wetness of the concrete in the sump. When the top float goes up the pump turns on, and when the bottom float goes down, the pump turns off. It takes about 25 seconds to pump the water out, MUCH faster than the previous pond pump. The sump form collapsed under the weight of the concrete so is not the oval I had planned, but looking at this pic now, the sump really resembles a fish, don’t you think. Especially with the corrugated edges where the tail would be.

I installed a tube into the concrete through which to run the pump hose and power line, so it would be hidden. There is a drain about one meter to the right of where the hose and line emerge. Once a trough is dug between the two, the hose will be almost hidden.  A trough will also prevent water from traveling along the surface toward the workshop path and kiln.

The unfortunate casualties of all this improvement are the frogs, and I am going to miss them. Hopefully they will find other low wet areas in the yard to hang out.

2 thoughts on “Here comes the flood”

Comments are closed.